---

Prox

---

All-in-one Wakasagi removal

---

■Installation width: 13mm or less
■Antenna total length: 14-83.5cm

---

★A decision board for removing smelt that is even easier to use.
Quickly remove the smelt hook and lead to fishing results.
Can be attached not only to the flat surface of the bucket, but also to corners and round buckets.
To install, just pull the trigger and clip it in, and it is compatible with aquariums and buckets up to 13mm.
Equipped with an antenna as a standard hanger. It expands and contracts from 14 to 83.5 cm, and can be set according to the length of the device.
By attaching a device to the hook, the needles can be handled smoothly without getting tangled with each other.
Put the smelt-covered needle through the slit, hold the chimoto (the part where the needle is tied), and lift it up to remove the needle.
The slit is made of aluminum, which is lightweight, durable, and difficult to get stuck. The angle can be adjusted to make it easier to remove the needle.
The counter can be installed on both sides of the main unit or as a single item. You can count the smelt you caught.

---